Fly of the week – Black Buzzer

Fly of the Week
Following on from last weeks ‘Fly of the week‘ is the Black Buzzer. Again, a buzzer is an imitation of the common chironomid midge. As the bloodworm matures and pupates the next step of it’s life cycle is the pupa. Possibly the most important stage to both trout and angler. This is the stage where the wings form inside it’s thorax and the pupae makes it’s way through the water column to the surface. It’s most vulnerable state.

Tying Instructions

Here I’ve used a Kamasan B110 hook, the heavier the hook the better when fishing a team of buzzers, the flies will fall quickly through the column and hold at the required depth when held by the fly line.

Start off by tying the thread to the hook a few millimetres from the eye and run the thread down the hook, around the bend and to about opposite the barb in touching turns.  UTC thread is the ideal component as it lies flat and spreads along the body very easily with minimum bulk.

The rib, Uni Soft Wire can be tied in at the top or bottom of the shank, I prefer to tie in at the top of the hook, this ensures that the wire is completely covered in two wraps of thread. Tie the wire in with touching turns and run the thread back to the top of the hook, leaving sufficient room for a thorax. Wind the silver wire rib back up the fly leaving equal spacings between each turn, this gives the banding effect which buzzers gain when they fill with air as they work their way to the surface. Finally, leave a gap of about 4mm behind the eye and tie off. Rib Complete.

Tying in Goose Biots. Simply take a goose biots from the stalk and tie in at the back of the thorax by the fine tips of the feather. Simply duplicate on the other side of the hook, and build a neat ‘lemon shape’ thorax (thicker in the middle) and secure with a half hitch at the eye, this helps keep everything in place in case of accidental slips. Pull the two biots forward and secure with a few turns of thread, build a neat head and tie off.

Fly tiers have recently been using a new UV reactive varnish called ‘bug bond‘. A varnish which is set with the use of a UV torch. Simply cover the fly in the glue, less of the glue the better, trying to keep everything as thin as possible but coating the fly for security and weight. Simple ‘zap’ the glue once applied for 15/20 second and the fly is complete.

 Material List

Hook: Kamasan B110 Size 10
Thread: UTC Black 70 Denier
Body: Black thread
Rib: Silver Wire
Thorax: Black Thread
Glue: Bug bond LITE

Fly of the week 1

Fly of the week 3

Written by Kieron Jenkins

4 thoughts on “Fly of the week – Black Buzzer

  1. Pingback: Fly of the week - Shipmans Buzzer | Fishtec Blog

  2. Pingback: Fly of the week - Simple Bloodworm Pattern | Fishtec Blog

  3. Pingback: Fly of the week - Black Buzzer | Fishtec Blog

Leave a Reply

Your email address will not be published. Required fields are marked *